As you can see, we've drilled a holy in the middle of this panel to start
the cut. Just cut outward to the edge of your design and begin to cut slowly.
Have patience or else this could be a disaster!
Here we are a little farther along in the cut. 2 hours later! Like i said-
it WILL take time so take a couple of breaks or you'll get in a rush.
Now is when you pull out your dremel tool (die cutter in our case) and carefully
smooth those edges with a sanding bit. You are not trying to cut with your
dremel- just smooth!
< Previous Page 1/3
|| Next Page 3/3 >