Painting Your Switch

Clear Enamel

Same process again, except this paint will go on completely clear. This adds a protective layer to the paint, to prevent chipping, and a bit of a gloss.


Turtle Wax



After all the painting and sanding is done, the last step in painting is to wax that baby up. Apply the wax in a circular motion, using the applier included with the wax. Wait a few minutes, and take a very soft cloth to it. Wipe the wax from the surface, and you should be left with one nice looking finish.






Wrapping It Up

Now you can remove the masking tape. Do this slowly, so you don?t grab any paint and chip it off.


After that, you?re ready to put the equipment back together and enjoy the fruits of your labor. Just screw those screws back in, and your done!








< Previous Page 3/5   ||   Next Page 5/5 >