|
LED Case Feet
Page: 1/4 Guide: LED Case Feet LED Case Feet Guide Introduction You can buy several different kinds of case feet. They may be lighted with led's and they may not. This Guide will show you how to make your own LED lighted case feet, using a few easy to aquire items. Disclaimer: Twistedmods and the author of this guide are not responsible for damage done to you or your computer because of this mod. You have been warned ahead of time of the risks involved, and by using this guide, the user assumes all responsibility for his/her hardware, software, life, and limb.
Materials needed 4 Transparent soda pop or water bottle lids. (I used the lids from half pint bottles of Ozarka spring water) 4 1/2" long screws with nuts. 4 5mm LED's (your choice of color) 4 Resistors (value of resistors will depend on the amount of the source voltage that you use) Hot glue gun with multi temp glue sticks. About 8ft. of two conductor wire. Heat shrink tubing (1/8 and 1/4 sizes) Foil tape and the usual.... soldering iron, solder, wire cutters,etc. Next Page 2/4 > |